Lowering your stang
11/27/05, 11:04 PM
#21
FR500 Member
Join Date: September 18, 2004
Posts: 3,108
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by emperorjordan@November 27, 2005, 6:45 PM
thats not lowered, is it?
I have the Steeda sport springs on the rear only. Lowered the rear one inch.
I like those wheels
thats not lowered, is it?
I have the Steeda sport springs on the rear only. Lowered the rear one inch.
I like those wheels
11/28/05, 09:13 AM
#22
Mach 1 Member
Join Date: October 13, 2004
Posts: 555
Likes: 0
Received 0 Likes
on
0 Posts
I would love to lower my car, but the roads in NW Ohio and SE michigan where I drive most of the time, are so terrible I just cant do it, maybe just the rear springs, dont know yet.
I put roush springs and tokico shocks on my 95 vert and it definitely looked awesome. But I can back up what another posted stated that if you use lowering springs, change the shocks to a set that is set up for performance lowering springs. on the 95 I did the springs drove it for about 4 months, hated the ride, (it was terrible), added the shocks later, the ride was totally better.
Good luck.
Sam
I put roush springs and tokico shocks on my 95 vert and it definitely looked awesome. But I can back up what another posted stated that if you use lowering springs, change the shocks to a set that is set up for performance lowering springs. on the 95 I did the springs drove it for about 4 months, hated the ride, (it was terrible), added the shocks later, the ride was totally better.
Good luck.
Sam
12/20/05, 06:10 PM
#23
Originally posted by acadian@November 15, 2005, 7:12 PM
I still think the best look is to just lower the rear 3/4" and level out the car. It's also the cehapest. As long as you have a dremel tool and some cut-off wheels lying around, it will cost you nothing. Just cut one full coil off the top of your rear springs to level the car out perfectly. Especially if you are going for the Shelby theme like me. The '67 GT350's bodies were almost a foot off the ground.
I still think the best look is to just lower the rear 3/4" and level out the car. It's also the cehapest. As long as you have a dremel tool and some cut-off wheels lying around, it will cost you nothing. Just cut one full coil off the top of your rear springs to level the car out perfectly. Especially if you are going for the Shelby theme like me. The '67 GT350's bodies were almost a foot off the ground.
Thread
Thread Starter
Forum
Replies
Last Post