2001 Bullitt #3006
#1123
Post *****
Thread Starter
Join Date: May 13, 2004
Location: Berkeley/Redwood City, CA
Posts: 18,613
Likes: 0
Received 3 Likes
on
2 Posts
...and apparently better on gas
just drove to my parents place today for Thanksgiving. Took a longer route to finally test the 87P tune (as opposed to the 91R) on a distance journey. Around town the 87P has been worse than the 91R (but I think the cause there is that the torque in the low end 87P had me gassing it more)
In any case, on my predominantly freeway drive home, I achieved 30.04mpg!! Who says new cars are the only ones with good mileage lol. This was done keeping it around 2k or so. cruising between 70-80mph.
All I can say is I can only recommend getting a tune for your modded 4.6 even more
just drove to my parents place today for Thanksgiving. Took a longer route to finally test the 87P tune (as opposed to the 91R) on a distance journey. Around town the 87P has been worse than the 91R (but I think the cause there is that the torque in the low end 87P had me gassing it more)
In any case, on my predominantly freeway drive home, I achieved 30.04mpg!! Who says new cars are the only ones with good mileage lol. This was done keeping it around 2k or so. cruising between 70-80mph.
All I can say is I can only recommend getting a tune for your modded 4.6 even more
#1125
Post *****
Thread Starter
Join Date: May 13, 2004
Location: Berkeley/Redwood City, CA
Posts: 18,613
Likes: 0
Received 3 Likes
on
2 Posts
I can get some in a few. its also filthy inside lol
I decided to order a set of steeda X2 balljoints and a bumpsteer kit as well. (gotta love the extended cyber monday deals lol)
The balljoints are making a lot of noise on my car anyway, and firestone said my outer tie rod was wearing as well. This, hopefully, will sort out my friend end noises, as well as the bumpsteer
I decided to order a set of steeda X2 balljoints and a bumpsteer kit as well. (gotta love the extended cyber monday deals lol)
The balljoints are making a lot of noise on my car anyway, and firestone said my outer tie rod was wearing as well. This, hopefully, will sort out my friend end noises, as well as the bumpsteer
#1126
Post *****
Thread Starter
Join Date: May 13, 2004
Location: Berkeley/Redwood City, CA
Posts: 18,613
Likes: 0
Received 3 Likes
on
2 Posts
i need to redo or extend my ghetto rear seat delete still, and the car is full of enough junk to negate a lot of my weight reduc lol, but i can't complain too much
#1128
Needs to be more Astony
Whats the point of the weight reduction if you add more weight in junk?
My friend did a bunch of weight reduction to his 01 GT. Aluminum bumper supports, coil over suspension, aluminum engine block.
With 1/2 tank of gas the car weight 3000lbs even now according to truck weigh station
My friend did a bunch of weight reduction to his 01 GT. Aluminum bumper supports, coil over suspension, aluminum engine block.
With 1/2 tank of gas the car weight 3000lbs even now according to truck weigh station
#1129
Post *****
Thread Starter
Join Date: May 13, 2004
Location: Berkeley/Redwood City, CA
Posts: 18,613
Likes: 0
Received 3 Likes
on
2 Posts
it has occurred to me before, but theres wires and I'm scared
fair point, but that junk would be in there whether or not the weight was removed from the car. I dont always have room in my room for my tools and things, and stuff i travel with just ends up staying in the car. so it still weighs less than it would have
Whats the point of the weight reduction if you add more weight in junk?
My friend did a bunch of weight reduction to his 01 GT. Aluminum bumper supports, coil over suspension, aluminum engine block.
With 1/2 tank of gas the car weight 3000lbs even now according to truck weigh station
My friend did a bunch of weight reduction to his 01 GT. Aluminum bumper supports, coil over suspension, aluminum engine block.
With 1/2 tank of gas the car weight 3000lbs even now according to truck weigh station
#1131
Post *****
Thread Starter
Join Date: May 13, 2004
Location: Berkeley/Redwood City, CA
Posts: 18,613
Likes: 0
Received 3 Likes
on
2 Posts
all thats really in the trunk is a small toolbox, another plastic cased tool kit and some assorted Harley parts for Pete's sportster. Inside is a mix of books, stuff I've rescued from my parents garage, school stuff and clothes
is everyone's car just empty? lol
is everyone's car just empty? lol
#1132
Join Date: December 5, 2006
Location: Trapped in Minnesota
Posts: 31,619
Likes: 0
Received 70 Likes
on
66 Posts
There's like two or three things to unplug. You just won't have anything to listen to but the door tweeters though.
Pretty much. Few things in the center console, and some stuff in the net in the trunk. I'm OCD.
Pretty much. Few things in the center console, and some stuff in the net in the trunk. I'm OCD.
#1133
NTTAWWT
I don't even have that net!
I keep a couple things in the car. Spare gallon of water in case it's needed, my toolbox in the trunk, and an air compressor. GPS, iPod, keys, and wallet get put in the center console.
I keep a couple things in the car. Spare gallon of water in case it's needed, my toolbox in the trunk, and an air compressor. GPS, iPod, keys, and wallet get put in the center console.
#1138
Legacy TMS Member
Originally Posted by cntchds
And on this edition of Hoarders we take a look at not a house, but a car that is brimming with things that are there "just in case."
#1139
Post *****
Thread Starter
Join Date: May 13, 2004
Location: Berkeley/Redwood City, CA
Posts: 18,613
Likes: 0
Received 3 Likes
on
2 Posts
If only I had a dog and a double barrel shotgun, I could mad max around all day. Still need to install the machete under the gas tank..
and if you guys hate this, good thing you cant see the II's interior lol. Its filled with parts that still need installing. and more tools
and if you guys hate this, good thing you cant see the II's interior lol. Its filled with parts that still need installing. and more tools
#1140
Legacy TMS Member
Originally Posted by future9er24
If only I had a dog and a double barrel shotgun, I could mad max around all day. Still need to install the machete under the gas tank..
and if you guys hate this, good thing you cant see the II's interior lol. Its filled with parts that still need installing. and more tools
and if you guys hate this, good thing you cant see the II's interior lol. Its filled with parts that still need installing. and more tools