Help. Do these ABs look properly lined up?

Reply Subscribe

Thread Tools

Search this Thread

9/15/13, 02:37 PM

#41

CVH

Bullitt Member

Join Date: March 12, 2013

Location: FL.

Posts: 399

Likes: 0

Received 0 Likes on 0 Posts

Quote:

Originally Posted by wilson68944

I'd like to have your opinion on whether my newly installed GT500 ABs are alligned properly. I feel the driver side axle-back is a little lower and juts out more. Let me know what you think? I'm debating whether or not to take it to Monroe or Meineke to re-allign it. It is driving me crazy.

Go for it dude. It's a 13mm socket. I just put my new upgraded brakes on my car, dropped her back down, and then decided to realign my GT500s after I took the floor jacks in. My car is low. 1.7in drop. I did it in under 5mins each side. No jacks needed.
Here is the result. Snug and centered.

Attached Thumbnails

Help. Do these ABs look properly lined up?-image-2896251610.jpg

Help. Do these ABs look properly lined up?-image-2466409118.jpg

Last edited by CVH; 9/15/13 at 02:39 PM.

Reply Like

9/15/13, 05:31 PM

#42

Siber Express

Legacy TMS Member

Join Date: May 19, 2010

Location: Clinton TN

Posts: 1,922

Likes: 196

Received 560 Likes on 363 Posts

Super easy to align, and to get the tip in you will need to loosen up the clamp at the over the axle pipe and mid pipe and slide it in there.
BTW I have seen a lot of Mustangs come out with one tip sticking out more than the other from the Factory.

Reply Like

9/15/13, 06:25 PM

#43

Ltngdrvr

GTR Member

Join Date: February 18, 2010

Location: S.E. Texas

Posts: 4,990

Likes: 0

Received 1 Like on 1 Post

For the tip sticking out too much, you may have to take the clamp loose between the mid pipe and over axle pipe to make the correct adjustment.

Reply Like

9/18/13, 09:35 PM

#44

wilson68944

GT Member

Thread Starter

Join Date: April 27, 2013

Posts: 121

Likes: 0

Received 0 Likes on 0 Posts

Thanks guys. I think I'm going to leave it for now. I am confident I could adjust the axle-back clamp but when we're talking about the H pipe I start to lose confidence that I could DIY. I was thinking of doing the Boss quads and if so I'll have the installer fix them.