What have you done to/with your Boss 302 this week?
Dropped it off at a local fabricator's shop to get a full rollcage, seat bases, racing seat, fire system, battery disconnect, etc.....
Ordered the following:
1. Rear Girdle from TA Performance (Need for Installation of Griggs Racing Torque Arm Kit.
2. K Member Brace with Engine Torque Limiters from CHE Performance
3. JPC Line Lock Kit
4. JPC Black Clutch Line Upgrade
5. 3 Quarts Redline 75W140 Gear Oil
1. Rear Girdle from TA Performance (Need for Installation of Griggs Racing Torque Arm Kit.
2. K Member Brace with Engine Torque Limiters from CHE Performance
3. JPC Line Lock Kit
4. JPC Black Clutch Line Upgrade
5. 3 Quarts Redline 75W140 Gear Oil
Vbstang13, you can get a hide away front bracket from American Muscle. I had one but some steep inclines and construction ditches not only damaged my bracket and plate, but actually cracked off about 8 inches of the outer lip from the bottom of my lower grille. If you have better roads down there it might be an option for you.
Same plate as you, BAD BOSS. The front sits in my truck in a broken under balance style holder so I always have a sob story for the officer. But so far the police have been respectful of my no front plate protest and never pulled me over.
Was going to do the bumper plug thing and went to take the bracket off yesterday and the dang screw the dealer used was to long and the bumper is scratched pretty bad and the start of a nice hole there also.
Looks like it's going to have to go to the body shop for some work and a repaint.
Dropped her off for installs:
1. Griggs Racing Torque Arm Kit
2. TA Performance Rear Girdle Super Low Profile
3. CHE K Member Brace with Engine Torque limiters
4. 3 qts Redline 75W 40 Gear Oil
5. JPC Braided Clutch Line
6. JPC Line Lock Kit
So far the TA and CHE are installed
1. Griggs Racing Torque Arm Kit
2. TA Performance Rear Girdle Super Low Profile
3. CHE K Member Brace with Engine Torque limiters
4. 3 qts Redline 75W 40 Gear Oil
5. JPC Braided Clutch Line
6. JPC Line Lock Kit
So far the TA and CHE are installed
Last edited by Boss949; Aug 16, 2013 at 02:17 PM.










