Adding Bi-Xenon HID kit
5/14/07, 06:59 PM
#1
Member
Thread Starter
Join Date: July 14, 2005
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Adding Bi-Xenon HID kit
Any of you guys who have added HIDs to your Stangs have any suggestions
on where to mount the ballasts. Just looking for ideas before I get into this.
Would appreciate any input
Thankx
on where to mount the ballasts. Just looking for ideas before I get into this.
Would appreciate any input
Thankx
5/15/07, 07:34 PM
#6
Cobra Member
Join Date: February 18, 2007
Location: SE PA
Posts: 1,301
Likes: 0
Received 0 Likes
on
0 Posts
I just stuck mine on the backside of the radiator support as mentioned earlier. I did the entire install in about 20 minutes. If I happen to have the bumper off again for another reason I'll stick them behind it.
5/16/07, 12:30 PM
#7
5/16/07, 01:00 PM
#8
Member
Thread Starter
Join Date: July 14, 2005
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
Hey thanks for all of the ideas guys, was going to mount them like mrkabc has in the headlight buckets, thanks for the pics (I believe Saleen does this to). The only thing is if something happens to one of the ballasts (doesn't work), I just don't want to have to take the whole front end off again. The radiator support sounds like another good option.
5/16/07, 03:50 PM
#9
Cobra Member
Join Date: April 20, 2005
Location: Orlando, FL
Posts: 1,477
Likes: 0
Received 0 Likes
on
0 Posts
must remember not to bust mrkabc's mojo... 
Thread
Thread Starter
Forum
Replies
Last Post