Ok so I got the whole MSD window switch hooked up except the yellow(or gray) wire that goes to the nitrous solenoid. I've got the zex kit that is all in the little box. How do I take the box apart and hook this wire up? I remember somone on here has done it and gave me some info before the forum went down. Now the thread is gone and I need that info again.

 

Ok I think I have an idea on the whole subject. Could you wire the grouding/opening wire behind the splice twards the zex box to activate the entire zex system when it hits the rpm.

 

Ok nevermind that would short the whole power circut. Could I use a relay to make it work?

 

Ok here's a picture to explain

 

#30: to +12v
#86: from activation circuit
#85: to -12v (to fuel pressure safety switch then ground, if equiped)
#87: to solenoids
#87a: unused

This may help.

-Dan

 

Eh its a little different because all the solenoids, fpss, wot switch, are all combined into the little zex box.

 

<div class='quotetop'>QUOTE(Shifty @ April 17, 2006, 6:59 PM) Quoted post</div><div class='quotemain'>
Eh its a little different because all the solenoids, fpss, wot switch, are all combined into the little zex box.
[/b][/quote]
A relay is a relay and thats how you correctly wire it but you will have to open up your box and mod it. There is a guy on allfordmustangs.com that did it that way.

-Dan