Convertible Owners, C'mon In Here.....
Member
Joined: May 23, 2007
Posts: 42
Likes: 0
I think there has been a couple of TSB's about the top but this one is new to me. I would still go after them.
Just remember sometimes these things go bad and instead of a wrinkle the new top might leak/not fit well and there will be a big scratch on your decklid.
Proceed with caution.
Just remember sometimes these things go bad and instead of a wrinkle the new top might leak/not fit well and there will be a big scratch on your decklid.
Proceed with caution.
B
Cobra Member
Joined: September 6, 2005
Posts: 1,296
Likes: 2
From: Colorado
You'll love the one touch top button. I hit mine and then by the time I've taken down the windshield sun screen and put on my seat belt I'm ready to go.
Bullitt Member
Joined: January 8, 2007
Posts: 409
Likes: 0
I had the top replaced on my 07 GT about a month ago and the driver's side rear just behind the rear window has a definite wrinkle. The work was farmed out from the ford dealer to a local upholsterer and I talked to him after I got it back and he told me the wrinkle would clear up on its own in about a month. Well it has been about a month and I am not noticing a big improvement. He did tell me that if it didn't clear up that I should bring it in to him and he would make it right. Has anyone had any experience with a sitaution like this and was it able to be corrected.
Ron
Ron
Bullitt Member
Joined: November 9, 2007
Posts: 241
Likes: 0
From: South Carolina
I have this upgrade. My first module was bad -- wouldn't raise -- service from WebElectric was super. He spent 45 minutes on the phone troubleshooting -- send me a new one and a pre-paid mailer to send back the old one for a QC determination. All are tested. I also installed sequentials. If you have Shaker 1000 -- the plug and play sequentials are more difficult -- cause you have to remove the subs or have very small hands.
The top module was pretty straightforward -- but you need a lot of light and care -- the wire harness is a bit close on some of the colors.
This is a top notch fun upgrade that works great.
The top module was pretty straightforward -- but you need a lot of light and care -- the wire harness is a bit close on some of the colors.
This is a top notch fun upgrade that works great.
Mach 1 Member
Joined: July 28, 2006
Posts: 971
Likes: 0
Has anyone done this with the traction control modification? The One-touch module cuts the red/black wire and the T/C modification needs that wire to connect to. What happens to the power to/from radio, since the wire is cut? Any thoughts?
Bullitt Member
Joined: May 17, 2005
Posts: 370
Likes: 1
Nevermind, I found it.
Mach 1 Member
Joined: July 28, 2006
Posts: 971
Likes: 0
Thread
Thread Starter
Forum
Replies
Last Post