Newbie Question...
#1
Newbie Question...
I've ordered a different shifter **** for my '16 Mustang GT, and I've watched the video on how to simply unscrew the stock shifter **** and screw the new one on. The problem I'm have is...I can't get the stock **** to break loose!! Obviously it takes more than just a strong grip and gritting your teeth (I've even tried adding a grunt or two). I'm not too concerned about damaging the stock shifter ****; so whatever it takes to get it off without bending something expensive. Any recommendations??
#3
When I removed mine I wrapped it in several layers of duct tape and then used a very large pipe wrench....Ford must have had a quota on how much lock tite they were supposed to use on the line the day my car was built !!!!
#5
#6
Cobra R Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
Thread
Thread Starter
Forum
Replies
Last Post
Fert Mosstank
'10-14 Exterior Modifications
9
7/27/16 07:11 PM
TMS Editor
Various Curated Content Articles
12
4/20/16 04:28 PM