Custom Matte Black Hood Stripe Added
10/30/12 | 03:55 PM
#21
Shelby GT500 Member
Joined: September 8, 2009
Posts: 2,586
Likes: 4
From: Lithia, FL
**** good price!! I should drive over and order one and tell them you told me I can get it done for $20 !! I had my GT rear valance painted instead but it's still on my list of changes someday down the road
10/31/12 | 02:05 PM
#23
GTR Member
Joined: November 6, 2011
Posts: 6,764
Likes: 19
From: Texas
Originally Posted by bill0754
I finally got around to designing my hood stripe after the 1970 Mustangs. My striper finished it today, so here are some new photos. The stripe matches the Hoodscoop and trim ring perfectly in color.
1/14/13 | 07:50 PM
#29
Thread Starter
Legacy TMS Member
Joined: August 9, 2004
Posts: 407
Likes: 1
From: Mount Dora, Florida
Update
Well, the difusser only cost me $115.00, but the install turned into quite a bit more work. The taillamps need to be removed, then the bumper. On the backside is an outline of the 4 slots that need to be cut and a line showing where to cut off a large chunk of the bumper. The dealer charged me $75.00 to do the install.
The dealer should give you the same price for the difusser. Just talk to Soloman at Sunstate Ford in Orlando at (407) 299-5900. Tell him you saw the one on my mustang.
As for the hoodscoop, it is attached to the engine and funnels air into the bottom of the factory airbox.
Attached are some more photos.
The dealer should give you the same price for the difusser. Just talk to Soloman at Sunstate Ford in Orlando at (407) 299-5900. Tell him you saw the one on my mustang.
As for the hoodscoop, it is attached to the engine and funnels air into the bottom of the factory airbox.
Attached are some more photos.
Last edited by bill0754; 1/14/13 at 07:52 PM.
Thread
Thread Starter
Forum
Replies
Last Post