Engine mods- help me out guys
8/1/11, 04:46 PM
#25
Mach 1 Member
Join Date: August 1, 2011
Location: Iowa
Posts: 802
Likes: 0
Received 0 Likes
on
0 Posts
Alright guys tell me what i should do.
My goal is to get as close as i can to 500 HP N/A without going into the internals of the engine.
1. I'm thinking of going with the JLT CAI
2. XC3 tuner (probably need a custom tune)
3. Exhaust (not sure which one yet- i like the gt500, corsa, borla s type and steeda)
4. X pipe
5. **maybe swap the boss 302 intake manifold and throttle body to get more**
What do you guys think i will get out of this? and what would you change to make this setup a little better?
My goal is to get as close as i can to 500 HP N/A without going into the internals of the engine.
1. I'm thinking of going with the JLT CAI
2. XC3 tuner (probably need a custom tune)
3. Exhaust (not sure which one yet- i like the gt500, corsa, borla s type and steeda)
4. X pipe
5. **maybe swap the boss 302 intake manifold and throttle body to get more**
What do you guys think i will get out of this? and what would you change to make this setup a little better?
if it were me, id go with a full borla ATAK exhaust system and their XR-1 long tube headers, boss 302 manifold, Ford Racing 90mm throttle body, 4.10 gears, CAI, a dynotech 1 piece driveshaft, driveshaft safety loop and a custom tune. and also run your car on the best gasoline possible.
Last edited by BlackMamba03; 8/4/11 at 11:08 AM.
Thread
Thread Starter
Forum
Replies
Last Post