Just a sub. But if you pull up that gray mat..there is absolutely nothing in the wheel well and all around the trunk. It should tighten things up with rattles. I hope.

 

which brand ya going with?

 

Not sure yet, nothing expensive.

 

Wax job last weekend.

 

Wow very nice. Excited to see how the trunk project turns out as well

 

How much? I'm about to list mine.

 

PM sent.

 

thanks

 

Picked up these hood struts from member Lewis26. I've been lazy and haven't installed them yet.

 

Where did you get this? Did you purchase this package somewhere?

Id like to do something just like this in my 13 GT

Your set up looks great and the car looks fantastic

 

Thanks dude. Go to partscheap.com...mustang interior. Both should total around 85.00.

 

Thanks, its going on the Christmas List! Was this a simple install?

 

Easy. Pop up the center console. The only hard part was taking off the boot bezel. Broke one tab but it doesn't show.

 

This installation (from partscheap) had me worried id be chopping up something brand new...

2010-2012 Mustang GT500 Alcantra Shift Boot
Part Number: AR3Z-7277-AA

"Installation: In order to make this work on a V6 or GT Mustang, some modification is required.
The diameter of the boot collar is slightly smaller than the stock boot, you will need to use a dremel tool, or a small knife to shave away a small amount of excess plastic. There is also a plastic spike coming down from the bottom of the collar. This can be cut and shaved away for flush fitment."

 

Don't worry there are about 9 tabs. If you break one or use a dremel to cut one off, it will not affect the boot.

 

Dynamat superlite ordered! (6 sheets)

 

Dynamat came in. Hope to start this weekend. I may need another box. 39.00 per box at onlinecarstereo.com

 

Not bad! Excited to see how it turns out

 

I used up every bit of the 2 boxes. There is some scraps left I'll use for any spots I missed. I would like to get 1 more box later to do the panel under where the rear speakers sit.

 

Any huge difference in the inside cabin noise levels after you put in that Dynamat?