hmm cant change it in my account settings....sry guys...

 

omg LMAO LOL!!!!!!!! hahaha dummies! lol

 

anyone going to the mustang get together at joe cooper tomorrow night? there are a couple of show cars coming in from ford for it.

 

Doc ... I think I missed the memo... whats going on tomorrow night?

 

me too, but i need a ride! blah....

 

Anyone check out the www. gomc.org site.?I'll try to be at joe cooper.What time?Tony ----PS-The locktite may not hold.The exhaust heat might make it run.Close to 1000 degrees.Use the self locking nuts

 

You make a good point on the loctite tony....looks like lockin nuts it is.

 

We really need to do it in Open Water. AKA... the lake. Dive Tulsa doesn't rent gear. You can borrow it if you are going for a cert. But since this a refamilar, you'll have to rent it.

Coming up, I'm doing another re-familiarization for another in a couple to few weeks, you could tag along.

Why do you need to do it so quick? Or do you just want to?

 

Mr. Cooper owe's me some cash. I doubt I will attend..... Not really in a Joe Cooper kind of mood... And yes, his license plate has been removed on the Roush!!

 

Since we're sponsored by BHF... Probably not a good idea....

As long as our sponsor is loyal to us, Which there are! I'll be loyal to them.

 

I just want to have it. There is no rush. I figure do it in the summer while it's still warm water, or warmer water at any rate. Where can I rent gear and when are you going to do that other refamiliarization?

 

I agree and I felt bad when BH saw my Joe Cooper license plate.... If I did go it would be in the Toyota..The Roush would stay in the garage!!! No sense in promoting a competitor's business especially when they have not honored all agreements for me even if I bought my car there!!!

 

yo
the message you have entered is to short

 

I checked and I used the Permatex High Strength locktite that is good to 300+ degrees. It says it can be used on block nuts and bolts. Well, the best I can do is hope it holds. The problem is that the stud is a particular thread pattern and it is ultra hard to match a nut to the stud, let alone a self locking nut.

 

is there a lock washer on there?

 

Nope, no lock washer...not a bad idea though I guess...

 

on one hand lock washers are over rated and on the other hand if your going to use one make sure its hardened.

 

http://www.dodgechallengercountdown.com/

 

Wrong site Glenn!

I think they will be pretty cool. We need some comp... it betters the breed.

 

that looks pretty bad ****! does anyone knw what kind of power its pushin?