Bullitt Reloaded
#21
The photoshop looks good, but it looks like he has the hood sitting lower at the cowl than the real thing?
#25
The hood has a higher centre section than the stock hood and a steeper rake down to the front - look closely at the manufacturer's image - to accommodate the cross-tower brace...not too keen on it myself...
#27
#28
AKA 1 BULLITT------------ Legacy TMS Member
Joined: January 29, 2004
Posts: 7,737
Likes: 343
From: U S A
I believe there is a kit available to extend and reroute the hoses which then mount on the wiper arms. I assume tie raps or clips are used to secure them in place.
#29
Looks like they are under the hood edge at the center.
Shows also how much higher the hood is. I suspect the top of the reverse vents is at the stock hood level. this would be how they created the hood and kept the underside seal for the CAI and clearance for the strut tower brace.
Shows also how much higher the hood is. I suspect the top of the reverse vents is at the stock hood level. this would be how they created the hood and kept the underside seal for the CAI and clearance for the strut tower brace.
Thread
Thread Starter
Forum
Replies
Last Post