JUST INSTALLED ROUSH SIDE SPLITTERS
#41
Shelby GT500 Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
Join Date: March 3, 2004
Location: Richmond VA
Posts: 2,633
Likes: 0
Received 0 Likes
on
0 Posts
I have the rears on my 2012. They are made for the 13-14. The lower valence on ours is longer so they are a little short but not bad. I'll take a pic of mine in a few so you can see
Last edited by conv_stang; 2/22/14 at 03:22 PM.
#42
Mach 1 Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
Join Date: July 19, 2011
Location: Albany
Posts: 547
Likes: 0
Received 0 Likes
on
0 Posts
I do not understand that. Not denying your wrong. The Roush splitter has 8 square tips that fit in the 8 square holes in the Rocker Panel. How can it not line up? If so I would send it back where you bought it from and have them send you a new one. Did you check the splitters on the bottom side? they are marked LH and RH.
Do they look like this. These are the Roush splitters each one of those 8 tips on each splitter goes up into the Rocker Panel:
![Smile](https://themustangsource.com/forums/images/smilies/smile.gif)
#45
Tasca Super Boss 429 Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
Had them on my sixer. Highly recommended and yes they do keep the dirt and splash down. I'd put them on my CS but torn between modding and keeping it original.
#46
GT Member
![](https://themustangsource.com/forums/images/rank.gif)
Join Date: January 28, 2014
Location: Georgia
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
Glad to hear it, they look good! Might have to go on my list, the list is getting pretty long though. do they look good by themselves or do they look dumb without the rear splitters?
#47
Tasca Super Boss 429 Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
I had them on a 2011...they look good on the 13 and up but are a bit more unified on the 10-12 because the black plastic matches directly. Either way, they rock! Once again, highly recommend.
Rear splitters are good either way also.
Rear splitters are good either way also.
Last edited by Getportfolio; 2/22/14 at 07:37 PM.
#48
GT Member
![](https://themustangsource.com/forums/images/rank.gif)
Join Date: January 28, 2014
Location: Georgia
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
#49
Banned
![](https://themustangsource.com/forums/images/rank.gif)
Thread Starter
Join Date: July 9, 2013
Location: Somewhere USA
Posts: 297
Likes: 0
Received 0 Likes
on
0 Posts
Yea there the right splitters just the drivers side one is defective i guess. The passenger side one fit perfect no problems. Its just that one. When i get time i take pics showing that its pushed back as far as it can go and still contacts the front mud flap mold on the rocker panel.
![Thumb](https://themustangsource.com/forums/images/smilies/thumb.gif)
Thread
Thread Starter
Forum
Replies
Last Post
roushcollection
Auto Shows and Events
0
7/28/15 02:08 PM