eromzek

Can anyone comment on any install advice to a not-so-steady drilling hand..?

GOFISCH

<div class='quotetop'>QUOTE(gkaufman @ February 17, 2006, 11:36 AM) Quoted post</div><div class='quotemain'>
These pedals are just awesome! The install took about an hour. I used some rubber approved super glue to make sure the little grips dont pop out. I did have to go buy some "flat-head" screws however... The ones supplied were dome shaped and looked quite ugly. The gas pedal was the easiest because you just use the sheet metal screws that dont need the nuts. I am still debating whether to paint the heads black or not.

Here are some pics... These are smooth with domed inserts.
[/b][/quote]


The super glue is a good idea, I was wondering about the domed screws. I was going to paint them and see what they looked like.

gkaufman

<div class='quotetop'>QUOTE(eromzek @ February 17, 2006, 1:11 PM) Quoted post</div><div class='quotemain'>
Can anyone comment on any install advice to a not-so-steady drilling hand..?
[/b][/quote]

if you start with the 1/8 bit you should have no trouble getting the hole drilled at the right spot. As far as bracing it... The clutch pedal just needs to be held at the "arm" section and just pull with your left hand and drill and push with your right hand. The brake pedal is easier since you can compress it a few times and get it to the point where it wont move much because the car isnt on.

Stangbang

I bought my pedals in the last group buy

I finally got them installed this wkend

i think they look pretty "freakin' sweet"

thanks to everyone involved in the group buy!

about the only thing better than the pedals is getting a deal on the pedals

congrats to everyone buying them now

you are going to love them!!!

GOFISCH

I finally installed mine. They look great, it didn't take as long as I thought it was going to. Even putting in the rubber grommets wasn't too bad.