Dead pedal from CDC now available
#101
Sorry, but we will not be able to work on the Mustang dead pedal this week.
We are swamped with large distributor orders.
We will try again next week.
Thank you for your understanding,
Rob
We are swamped with large distributor orders.
We will try again next week.
Thank you for your understanding,
Rob
#103
Shelby GT350 Member
That CDC dead pedal is too small and really doesn't cover enough of the carpet. I bought the accelerator and brake pedals but I will not be buying that dead dead pedal. I have been trying to train myself NOT to put my foot on the carpet which has always been a instinct for me.
I remember the 1994-04 Mustangs had an available factory dead pedal which could be added to cars without them. All cars had the hole in place behind the kick panel and the one CDC has for the newer Mustangs mounts and installs the same way.
I remember the 1994-04 Mustangs had an available factory dead pedal which could be added to cars without them. All cars had the hole in place behind the kick panel and the one CDC has for the newer Mustangs mounts and installs the same way.
#104
GT Member
Join Date: January 25, 2008
Location: Malvern, Pennsylvania (SE Pennsylvania)
Posts: 158
Likes: 0
Received 0 Likes
on
0 Posts
Very nice. I have searched high and low for this exact part. $59.95 isn't bad. It will match the pedals on the Bullitt very well. The metal is a little too flat though. It should have some raised areas to match the gas pedal. See what I mean?
http://www.classicdesignconcepts.com...t_detail&p=127
http://www.classicdesignconcepts.com...t_detail&p=127
Last edited by newdy22; 4/14/08 at 04:58 PM.
#107
V6 Member
Join Date: March 23, 2008
Location: Port Saint Lucie, FL
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
I just installed the pedals last night. I had to cut the carpet very slightly where it couldn't be seen to get the carpet to lay right with the dead pedal.
#108
Very nice. I have searched high and low for this exact part. $59.95 isn't bad. It will match the pedals on the Bullitt very well. The metal is a little too flat though. It should have some raised areas to match the gas pedal. See what I mean?
http://www.classicdesignconcepts.com...t_detail&p=127
http://www.classicdesignconcepts.com...t_detail&p=127
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
'10-14 V6 Modifications
1
9/23/15 03:21 PM
tj@steeda
2015 - 2023 MUSTANG
0
9/8/15 10:45 AM