Here are a couple pics after recently installing the Ford Racing hood pincs, as well as having gloss black vinyl racing & rocker stripes installed.

First, the front...

 

One from the rear...

 

One from the side, showing the rocker stripes...

 

looks good dude

stripe combo is coolio too

 

Nice wish I had mine so I could start modding.

 

darn! That is sweet! Good Job.

 

Could you post a picture with the hood up? I would like to see the installation process. Looks very nice!

 

Rich... I'll see what I can do. Might not be able to until next weekend. But basically, I drilled the holes into the frame of the car where the hood pins where going to be, thinking that I would have enough room to bolt them down, but they were too short. If I had bolted them at their highest point, the holes in the pins for the clips would have been slightly hidden under the hood of the car. So, I placed the pins in the holes, with a nut threaded onto the pins holding them vertically at the right height, and welded them in. Then, I just painted the weld. Eventually, I'll try to find some sort of black rubber or plastic cover/sleeve to put over the pin and hide the weld.

 

That's sharp looking!!!

 

Your car is looking great! I like the rocker stripes being plain like that....no lettering or numbers. The "GT" just above them says plenty!

 

Looks great Acadian You done a fine job on that mustang of your's B)

 

Acadian, it looks fantastic!

I justed noticed you used 1" spacers on your rims. They look really good pushed out.

I'm hoping to get wider rims and achieve the same look eventually! Pushing the rims out really seems to make the wheel/fender gap look smaller. Its not that bad stock IMO, but it looks even better with the spacers.

 

Thanks for the compliments. I'm trying to make it as retro/Shelby'ized as possible. I will be getting a ducktail of some sort and then eventually painting the stripes on. As well as possibly a new hood with a scoop, depending on what's out when I get the stripes painted.