Fitment Issue - 3dCarbon GT500 Spoiler
#41
Unfortunately, shortly after installing my 3d Carbon GT500 Spoiler, I noticed that it does not fit well along its forward edge. A gap has formed on both sides, but more so on the passenger side. The double-sided tape can’t even keep it together. If fact the tape is releasing leaving some attached to the deck lid and some attached to the spoiler. I followed the instructions very carefully, including only hand tightening the two bolts. It would appear that this why the OE Shelby GT500 spoiler utilizes four bolts/studs for attachment. These comments were forwarded to 3dCarbon last Friday, and still no response from them. Following are some close-up pictures:
peel it off....apply new 2 sided tape to the spoiler, clean really good then let the car sit in the sun with the spoiler in its place ( with the tape not peeled on the car side) if its warm enough where you live you will be cool with doing jsut that that ...you will notice as the spoiler heats up in the sun ( if its cold where you are use a blow dryer in an enclosed area) it will lie down and follow factory lines...then peel and stick.....looks to me like it was cold when you put it on and somewhat rigid...the stuff thats made out of if warmed will do exactly what you want it to...fwiw
#42
peel it off....apply new 2 sided tape to the spoiler, clean really good then let the car sit in the sun with the spoiler in its place ( with the tape not peeled on the car side) if its warm enough where you live you will be cool with doing jsut that that ...you will notice as the spoiler heats up in the sun ( if its cold where you are use a blow dryer in an enclosed area) it will lie down and follow factory lines...then peel and stick.....looks to me like it was cold when you put it on and somewhat rigid...the stuff thats made out of if warmed will do exactly what you want it to...fwiw
#43
Team Mustang Source
Thread Starter
Join Date: January 15, 2005
Location: So. FL
Posts: 1,426
Likes: 0
Received 0 Likes
on
0 Posts
I talked to 3D Carbon last week again, and they offered to send me a newly revised version of the spoiler. It uses the 2 bolts, plus 2 more bolts on the outlying egde that will have to be drilled through the trunk, to prevent the ends from trying to come up. It should be here next week, and I'll let you guys know how it went.
My advice is to talk to 3D Carbon and ask about getting the new 4 bolt version if you are having problems with your current spoiler.
My advice is to talk to 3D Carbon and ask about getting the new 4 bolt version if you are having problems with your current spoiler.
I'll give 3dCarbon a call.
Thread
Thread Starter
Forum
Replies
Last Post
Antigini-GT/CS
2005-2009 Mustang
5
10/5/15 09:43 AM