Mine scrapes since we have some inclines around here.

Anyways, what are the stock clearance measurements?

-Dan

 

more pictures i just snapped outside.

 

... and yes i told them to drill front plate holes for those of you who find them for whatever reason offensive....

 

Looks sweeeeet! Nice job!








Cheers_Jay

 

looks great...and no alignment probs...killer!

 

Me likee

 

Emilee: Looks great. Are you planning on changing the wheels? I like wheels with a larger offset but would like to see if they will fit within the wells.

 

Looks sweet Girl

Keep it up, with the mods and all!
and by the way, your car is far from "rice" as stated by someone on page 1

Nice job

Nick

 

Hey, where did you take those clearance measurements from?

I just recorded my clearance at the front and rear on the underside of the rocker panel ground effects and came up 3 7/8" front and 4 1/2" rear.

When comparing these measurements to that of a stock GT sitting on a dealer's lot it seems the drop is good for about 2.5" up front and 2 3/4" in the rear. Your drop seems right on par with my numbers.

-Dan

 

what do you mean clearance measurements? like how did we determine how far it went down? We measured it before we installed the springs, and then after... but we measured from the ground to the top of the wheel well on the front and back. I don't have the measurements we took to determine this though, we just scribbled it on something that was on a table in the garage... not my garage... so i don't have whatever we wrote down sorry

Yep, i'm planning on putting different wheels on pretty quick. I had a set picked out and was waiting for them to be in stock (19s... 9.5 front and 10 rear) but now i'm not so sure... i might want something else... so i'm still looking

 

I meant ground clearance, ya know....easing through dips and bumps so ya dont bottom out.

-Dan

 

Post pics as soon as you decide and/or get them installed.