View Poll Results: Will I hit 11's with these parts?
Yes



5
15.63%
No



17
53.13%
Maybe



10
31.25%
Voters: 32. You may not vote on this poll
Could I hit 11's N/A with these parts?
Most people cant shift very well(not saying you cant)
...But with cams full exhaust and whatever else he is planning I can see mid 12s all day with low 12s being possible on a good tire and good driving
You forgot that I put cylinder heads too so cams,heads,full exhaust,gears,intake,tune,udp's,headers,lca's,uca' s,driveshaft,tubular radiator support and cmdp's should do low 12's all day and maybe a 11.9 or 12 flat on a really good day right?
i have seen someone who dynoed 367rwhp,ran 12.17@111 and 12.2 @113,he had heads,cams,mufflers,shorty headers,o/r x-pipe,3:90 gears,lca's,rear wing delete,spare and jack out,springs,shifter,no swaybar,93 tune,k&n cold air intake(he should be using the c&l racer to support heads and cams),stock tires. And he says he was at the worst track in the US,Bristol Tenn. So this guy could've ran 11's at a better track,and since he would not have as much hp as my list(cause he doesn't have lt's or a big intake or heads with 1mm oversize valves), I could probably run 11's.
i have seen someone who dynoed 367rwhp,ran 12.17@111 and 12.2 @113,he had heads,cams,mufflers,shorty headers,o/r x-pipe,3:90 gears,lca's,rear wing delete,spare and jack out,springs,shifter,no swaybar,93 tune,k&n cold air intake(he should be using the c&l racer to support heads and cams),stock tires. And he says he was at the worst track in the US,Bristol Tenn. So this guy could've ran 11's at a better track,and since he would not have as much hp as my list(cause he doesn't have lt's or a big intake or heads with 1mm oversize valves), I could probably run 11's.
Thread
Thread Starter
Forum
Replies
Last Post
Detroit Steel
General Mustang Chat
4
Sep 21, 2015 03:35 PM



