have tracking #s been emailed? because I haven't gotten a PM

 

Derek,

They should have gone out with the shipment to your email address? I will call and get your tomorrow.

Being in Texas, you should see yours Thursday. THANK YOU SIR!

CR
Tillman Speed

 

I was so stoked when I got these I missed a little something. I would like opinions on what I should do. One of the primaries has what looks like one of a few things. There is a spot on it that looks like it either had a small hole that was filled by a weld or when they were being welded it arced to the table or maybe a stray touch of the welder electrode. I do not have pictures right now. It is small!!! the rest of the welds and such are top quality. Should I be concerned abouit this little sport or not? Picture to follow.

 

Sounds good for the headers, what about the CMCV delete plates, MILs, etc.?

 

Ok here are the pictures.

Something to be concerned about down the road?

or

fagetabout it?

 

better pic of the whole thing.

 

I can't tell how deep it is. It doesn't look like it will be a problem at all, I just want to see how deep it goes into the metal. I don't forsee any issues.

CR

 

for anyone concerned with ground clearance. my car is dropped 1.5" with the FRPP lowering springs and here are the ARH headers, H pipe, stock over axels, and FRPP stinger mufflers

 

as you can see you cant even see them and my torque limiter is the lowest part of my underbody haha

 

Headers are getting installed as we speak. I'll have the car back tomorrow!! Plus, I finally met the famous CR! Class act top to bottom Even gave me a ride back to work! Can't wait till I pick it up tomorrow, and we'll finally hear the new sound of my car!!!

 

I forget...Are we still waiting on before/after dyno numbers and videos from someone or is that not going to happen now?

 

Congrats man!!! Looking forward to hearing how they sound and about your impressions.

 

I was still waiting on some numbers here as well.

 

Hey Jeff, cant wait to here your set up.. I finally got my car back!! stripes came out really nice. I'm gonna post some pic's later this week.

 

how much are these headers? will this fit the stock pipes? can I just get the headers? thanks

 

If you read my post above, my car is getting them installed NOW! CR will have the before and after dyno runs, and video taken and posted within 12 hours!!!

 

See my above post (and post #170)!! Don't some people pay attention?

 

Me too Rafael. I'd like to see some pics of your car when you get them up.

 

well i have some i took w/my camera phone.. not the best pic's. Maybe I'll try and upload them later.

 

I was replying to his post about waiting, not your post about getting yours installed. Calm down.




I'm anticipating hearing your setup