AEM Tru Boost Setup How To?
Thread Starter
GT Member
Joined: March 22, 2007
Posts: 125
Likes: 0
AEM Tru Boost Setup How To?
Anyone have a good setup on how to set this up? I've heard conflicting ways.
- click left button and get into your desired program "a" in my case.
- click both buttons get into PrG mode program mode
- click left button and get into program mode "a"
- make sure spring pressure is set to 1
- click left button to get into “a”
- start at 10 duty cycle setting “a” and increase by 3 or 5
- go WOT in 3rd or 4th see what boost level you get.
- Continue to increase until you reach 13PSI at WOT
- Go back to SPR spring pressure and adjust by one.
- Go WOT until you go over by one and then back the SPR back by one that’s it.
Thread
Thread Starter
Forum
Replies
Last Post
Fred_Garvin
2010-2014 Mustang
4
Sep 17, 2015 04:10 PM
