Pics of Steeda Intake Installed
#1
V6 Member
Thread Starter
Join Date: May 30, 2011
Location: Woodstock, GA
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
Pics of Steeda Intake Installed
All-in-all, not a bad install. I did deviate from the instructions at one point by installing the factory cold air feed, then installing the Steeda airbox (instructions call for installing the feed onto the airbox, the installing the entire unit together...I couldn't get it to work that way). There was one piece that appeared to be missing; a plug for capping the hole left after the removal of the factory cold air feed resonator. The plug included was way to small (talking to Steeda now about that). You can see the hole that needs to be plugged right in front and below of the airbox.
<Edit: plug is on its way, just didn't make it into this particular kit.>
<Edit: plug is on its way, just didn't make it into this particular kit.>
Last edited by silver86; 3/6/15 at 02:44 PM.
#4
That looks Great! The airbox looks much better than then pictured on the Steeda website. Did you get it with or without a tune? How does it sound -- do you get a nice induction roar when accelerating?
#5
V6 Member
Thread Starter
Join Date: May 30, 2011
Location: Woodstock, GA
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
I don't believe the tune is ready yet, so I'm still running my Bama 93, with the restrictor installed (which is actually a pretty slick piece on its own).
I just putted around the neighborhood yesterday, so no feedback yet on WOT sound or feel.
I do have to say, I found it interesting that the box seals almost entirely against the hood and under the upper fend trim (can see it in the first pic, you have to tuck the box and gasket [which is installed around the entire box]). It appears the it truly only pulls are from the factory cold air feed and from the hood vent.
I just putted around the neighborhood yesterday, so no feedback yet on WOT sound or feel.
I do have to say, I found it interesting that the box seals almost entirely against the hood and under the upper fend trim (can see it in the first pic, you have to tuck the box and gasket [which is installed around the entire box]). It appears the it truly only pulls are from the factory cold air feed and from the hood vent.
Thread
Thread Starter
Forum
Replies
Last Post
ustabawannab
Suspension, Brakes, and Tire Tech
5
8/5/15 08:32 PM
tj@steeda
Ecoboost
1
7/25/15 06:32 PM