6r80 swap abs problems
#21
Mach 1 Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
To be clear. I am sorry for confusion. Two different things going on here. I did not mean to imply the lack of an aspirator was the cause of the ABS light being illuminated. I am however making a claim that the booster will not have enough vacuum to operate properly under wide open throttle without the aspirator assembly.
#22
Mach 1 Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
To be clear. I am sorry for confusion. Two different things going on here. I did not mean to imply the lack of an aspirator was the cause of the ABS light being illuminated. I am however making a claim that the booster will not have enough vacuum to operate properly under wide open throttle without the aspirator assembly.
LEXiiON
#23
Mach 1 Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
Oh yeah. I didn't believe you were. Sorry for any confusion there too. I just re-read my posts and even I thought that's what I was indicating. :-) No worries man.
#24
Mach 1 Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
#27
V6 Member
Thread Starter
#29
Mach 1 Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
LEXiiON
#32
V6 Member
Thread Starter
Mine is all done now with no more fault lights. I use a vmp tune with my tvs. I like the way it shifts, but it is too cold to put down much power with stock tires
Last edited by lx92coupe; 1/23/16 at 06:00 PM.
#35
Member
Join Date: March 19, 2015
Location: Strongsville OH
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
I am in the middle of the 6r80 swap, can anyone tell me what to do with the clutch fluid line? Do I take it out of the engine bay where it is against the firewall by the brake booster? If I cap it off, what do I use? How does the shifter cable from the trans attach to the shifter? Does it just go on that piece sticking out? Doesnt look like that would hold it very well. Does the trans cooler go inside near the fans? I have the roush tvs supercharger and does not look like it would fit anywhere...Is their a way to tell what gear the transmission is in so it matches with the shifter? Thx
#37
Member
Join Date: March 19, 2015
Location: Strongsville OH
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
#39
Member
Join Date: March 19, 2015
Location: Strongsville OH
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
I asked if they still have the abs from vehicle, waiting to hear back. So if i get that one, i just install abs and then pmi my pcm with donor car vin?