This may seem a little far fetched but I am thinking of putting cutouts that attach to the Boss 302 side exhaust. Basically when I open the cut outs, the exhaust will go out the side exhaust and when I close them, they will run to the rear of my car to the axle backs. Would this be at all possible?

 

Yes it's possible, that will be nice to have the option, louder on the side...

 

The thing is, you'd want the cutouts to be before the side exits on the Boss H-pipe - the piping diameter is not large enough to be the sole exhaust routing. It's meant for sound to be routed through, not exhaust pressure. So you'd want your cutouts to dump before the side piping. That make sense?

 

What I was thinking was completely custom now that I think about it. I would install an X-Pipe. After the X-Pipe I would have a Y-Pipe on each exhaust tube. One end of the Y would pass through to the rear and the other end would go to a cut out. Then I would attach the Boss side pipe to that Y where the cut out is installed. So is this just crazy?