Finally started the Super Shaker install ...
#21
Shelby GT350 Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
Thread Starter
Join Date: September 11, 2006
Location: Cumming, GA
Posts: 2,349
Likes: 0
Received 4 Likes
on
3 Posts
The SuperShaker comes with a 3.6" Pulley advertised at 8 PSI and 500HP at the crank.
I bought the entire setup for $5900 shipped from JDM Engineering. That included a tune for my 2010 since Saleen does not offer one for a 2010 with a SuperShaker.
JDM was nice enough to pull some strings at Saleen and have them build me a Supershaker kit with the updated 2010 Engine coolant and Heat Exchanger setup.
I bought the entire setup for $5900 shipped from JDM Engineering. That included a tune for my 2010 since Saleen does not offer one for a 2010 with a SuperShaker.
JDM was nice enough to pull some strings at Saleen and have them build me a Supershaker kit with the updated 2010 Engine coolant and Heat Exchanger setup.
#22
Shelby GT350 Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
Thread Starter
Join Date: September 11, 2006
Location: Cumming, GA
Posts: 2,349
Likes: 0
Received 4 Likes
on
3 Posts
IT'S ALIVE!!!
It's pouring rain in Georgia so I am stuck in my garage with not much room to work but it was killing me to be so close and not running yet.
I finished up all the Wire Harness modifications, Vacuum and EGR mods, filled the Radiator up with Coolant and loaded the JDM tune.
I turn the key and .... VROOOM ... starts right up and idles perfect. No codes, no crazy noises or smoke and Vacuum Gauge is reading 20 just like it should. After making sure all looked good a couple of taps on the gas peddle adds to boost and my WideBand numbers are looking good. Of course real test will be on the road on a drier day.
All I have left now is to hook up the Heat Exchanger hoses, finish wiring the Water Pump, and fill the Intercooler with Coolant!
It's pouring rain in Georgia so I am stuck in my garage with not much room to work but it was killing me to be so close and not running yet.
I finished up all the Wire Harness modifications, Vacuum and EGR mods, filled the Radiator up with Coolant and loaded the JDM tune.
I turn the key and .... VROOOM ... starts right up and idles perfect. No codes, no crazy noises or smoke and Vacuum Gauge is reading 20 just like it should. After making sure all looked good a couple of taps on the gas peddle adds to boost and my WideBand numbers are looking good. Of course real test will be on the road on a drier day.
All I have left now is to hook up the Heat Exchanger hoses, finish wiring the Water Pump, and fill the Intercooler with Coolant!
#27
GT Member
![](https://themustangsource.com/forums/images/rank.gif)
Join Date: December 3, 2010
Location: STL, Missouri
Posts: 147
Likes: 0
Received 0 Likes
on
0 Posts
Yeah, but in his defense the out of place blue valve covers seem to be a Ford "performance" thing....
Last edited by 944withnos; 2/2/11 at 11:31 PM.
#29
Shelby GT350 Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
Thread Starter
Join Date: September 11, 2006
Location: Cumming, GA
Posts: 2,349
Likes: 0
Received 4 Likes
on
3 Posts
Well it's been 6 days of working on it for a total of around 16 hours .... and the install is finally complete!! Mounted the Scoop and Trim Ring tonight.
I trimmed down and used the CDC trim ring on top ... The trim is around 1/4 wider than the Saleen trim so I think it finishes it off nicer.
Unfortunately it's been pouring rain all day in GA ... so hopefully the test drive is tomorrow!
I wired my pump Roush style .. to the CMCV connector that was no longer being used. Saleen has some crazy wiring scheme into the SJB inside the passenger side kick panel.
I trimmed down and used the CDC trim ring on top ... The trim is around 1/4 wider than the Saleen trim so I think it finishes it off nicer.
Unfortunately it's been pouring rain all day in GA ... so hopefully the test drive is tomorrow!
I wired my pump Roush style .. to the CMCV connector that was no longer being used. Saleen has some crazy wiring scheme into the SJB inside the passenger side kick panel.
Last edited by dmhines; 2/4/11 at 05:21 PM.
#33
Shelby GT350 Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
Thread Starter
Join Date: September 11, 2006
Location: Cumming, GA
Posts: 2,349
Likes: 0
Received 4 Likes
on
3 Posts
Yes it is drivable in the rain. However the Mustang does not get driven in the rain ... hasn't been in the rain since sitting on the dealer lot before I bought it.
The Shaker is designed to catch rain water before going into the intake and then drain it out the bottom. Since I don't do rainy day driving ... I didn't bother to install the drain hoses which makes for a prettier install ....
The Shaker is designed to catch rain water before going into the intake and then drain it out the bottom. Since I don't do rainy day driving ... I didn't bother to install the drain hoses which makes for a prettier install ....
#34
Legacy TMS Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
Oh ok cool. I always wondered about that. I wish I was lucky enough to have another car that I can switch between but for now my Mustang gets all weather duty. ![Frown](https://themustangsource.com/forums/images/smilies/frown.gif)
BTW your car looks great with the SS on it ... AWESOME WORK
![Frown](https://themustangsource.com/forums/images/smilies/frown.gif)
BTW your car looks great with the SS on it ... AWESOME WORK
#36
GTR Member
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
![](https://themustangsource.com/forums/images/rank.gif)
Thread
Thread Starter
Forum
Replies
Last Post
mustanglindsey
Repair and Service Help
5
8/3/15 09:07 AM