5.0 Trunk Badge
#2
Legacy TMS Member
Join Date: December 23, 2011
Location: Indianapolis, IN
Posts: 384
Likes: 0
Received 0 Likes
on
0 Posts
I think it looks really good! Just something a little bit different to make your car stand out, and it's probably just the angle of the picture, but the "5.0" badge looks slightly crooked
#5
Mach 1 Member
Join Date: August 21, 2011
Location: Morgantown, West Virginia
Posts: 668
Likes: 0
Received 0 Likes
on
0 Posts
I like the panel too. Is it noticeably plasti-dip? I've never plasti-diped something that large. I have the panel but it doens't really fit that well.
#6
Nice.. where to get the emblem? Im considering it but I would get rid of my 5.0 license frame
Plasti Dip is wonderful
Plasti Dip is wonderful
#8
Member
Thread Starter
Join Date: September 17, 2011
Location: Sacramento, CA
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
http://www.emblempros.com/inc/sdetail/16286
Here is the link to where I got the trunk badge. The installation is quite time consuming. The hardest part is getting the badge off without scratching your paint or the badge itself. I think it's worth it though.
The plastidip looks great in person. I actually had the panel plastidipped before but scratched it a bit doing the 5.0 badge install. I peeled it off and reapplied after install.
Here is the link to where I got the trunk badge. The installation is quite time consuming. The hardest part is getting the badge off without scratching your paint or the badge itself. I think it's worth it though.
The plastidip looks great in person. I actually had the panel plastidipped before but scratched it a bit doing the 5.0 badge install. I peeled it off and reapplied after install.
Thread
Thread Starter
Forum
Replies
Last Post