Trying to think of somehting different than the GT on the sides. Would this cover the holes in the fender its 3"x1.5".

 

Yeah, that definately looks like it would.

 

Seems like it will but I dont know how far apart the holes are. Just wanted to check before I shell out 25 bucks and grab the heat gun

 

Do a search, I know there has been a topic showing the holes both in the fender and on the back of the GT emblem. I don't believe the holes are much more than an inch apart.

 

Since Cobra Snakes will cover them, I'm sure that will... That's a cool badge...

 

I know I have seen threds in the past but I couldnt find it again. I think im going to try it and see.

I like them as well...I want to not have a GT like every one else but I also dont really want something its not like a cobra (no offence to anyone ) So I figgure its not to flashy and looks like it could be stock even. Then the next plan is to get my rear gas cap airbrushed just in the center part. Maby just black with 281 in it...dont know just yet.

 

Nice badge! I like it~

 

A fellow TMS member was nice enough to send this to me so I will "pass it on" Should give you where the location and distance apart the current holes are

 

Perfect...now I will just go see how tall the GT is. I need 1.5"

Hope its there because I ordered the badges yesterday

If anyone can throw a tape on there GT let me know. Im at work and cant go look right now I am looking at a tape and 1.5" isnt much...hope it covers them.

 

OK couldnt take it...so I went and looked at it. Its going to be close, I think the GT might be a little over 1.5".....

 

Check this link out -

http://forums.bradbarnett.net/index.php?sh...89&hl=gt+emblem

 

Holes are 1 1/8" apart, not quite vertically spaced. I measured the pins on the GT emblem.