New body parts installed
1/27/07 | 01:58 PM
#3
Thread Starter
Bullitt Member
Joined: November 16, 2006
Posts: 434
Likes: 0
From: Knoxville, TN
Got the emblem from MustangsUnlimited.com. It is a Scott Drake replica from a 65 mustang side fender. Took the little pins off of it and just used some 3m tape to hold it in place.
1/29/07 | 12:55 PM
#10
Team Mustang Source
Joined: August 3, 2005
Posts: 1,652
Likes: 2
From: Mustang/Tuttle, Oklahoma
Looks great Bill!!!!! Love the offset tribar pony emblem and the spoiler. I've done those same mods myself. You have excellent taste. Did you just stick the pony emblem to the grill? Is there enough surface area on the grill for it to adhere to? I made a bracket and did a write up on it. Anyway, your car looks great!!!!!!!!!
1/29/07 | 01:43 PM
#11
Thread Starter
Bullitt Member
Joined: November 16, 2006
Posts: 434
Likes: 0
From: Knoxville, TN
Looks great Bill!!!!! Love the offset tribar pony emblem and the spoiler. I've done those same mods myself. You have excellent taste. Did you just stick the pony emblem to the grill? Is there enough surface area on the grill for it to adhere to? I made a bracket and did a write up on it. Anyway, your car looks great!!!!!!!!!
Thanks Rob.
I kind of modeled it after a few on the site. (did my research first). The emblem I ordered had the 3 pins on the back. I just cut them off & used some 3m tape. I think it has some good contact to the grille. Had it sitting in my living room for about 3 days before I could put it on the car & every day I would try to pull it off, but it stuck good.
I saw your write up & would have done the same, but I was too eager to get it on. If it does seem to be coming off, then I will go your route.
Ordering the 1/4 louvers tonight to finish the look.
1/29/07 | 05:28 PM
#12
Bullitt Member
Joined: June 23, 2006
Posts: 427
Likes: 6
From: Wallingford CT
How is the fit and finish of the 3d500 spoiler? Are they still using only two of the four existing bolt holes? I heard they were moving to the four. I am inerested in getting that spoiler. I like the idea of it being pre-painted......Car looks very good from pictures. How was removing the old spoiler?
1/31/07 | 10:34 AM
#13
Mach 1 Member
Joined: December 18, 2004
Posts: 669
Likes: 0
How is the fit and finish of the 3d500 spoiler? Are they still using only two of the four existing bolt holes? I heard they were moving to the four. I am inerested in getting that spoiler. I like the idea of it being pre-painted......Car looks very good from pictures. How was removing the old spoiler?
Thread
Thread Starter
Forum
Replies
Last Post