Nice Build in Wheatland California Today!
#1
Team Mustang Source
Thread Starter
Nice Build in Wheatland California Today!
Ryan is upgrading his 05 Saleen powered GT by doing the following;
JDM stroker shortblock
-GT500 oil pump
-MMR stage 2 P&P heads w/ Manley 1mm oversized valves & Manley springs
-ARP bolts and studs
-60# Siemens Deka fuel injectors
-SCT BA-2400 mass air flow meter
-Centerforce DF clutch
-Fidanza aluminum flywheel
-Innovators West 8" crank pulley/balancer
-BGG performance 3.2" blower pulley (2.95" to follow after break in)
-Gordsford heat exchanger
-JDM tunes of course
-GT500 Throttle body w/ported intake to accomodate
-All SS braided hoses w/red-blue aluminum hose ends
Hung out today with Chad, Ryan and Nick. Ryan and Nick were doing the wrenching and I was opening beers. Chad was offering tech support. Wrenching and beers~
JDM stroker shortblock
-GT500 oil pump
-MMR stage 2 P&P heads w/ Manley 1mm oversized valves & Manley springs
-ARP bolts and studs
-60# Siemens Deka fuel injectors
-SCT BA-2400 mass air flow meter
-Centerforce DF clutch
-Fidanza aluminum flywheel
-Innovators West 8" crank pulley/balancer
-BGG performance 3.2" blower pulley (2.95" to follow after break in)
-Gordsford heat exchanger
-JDM tunes of course
-GT500 Throttle body w/ported intake to accomodate
-All SS braided hoses w/red-blue aluminum hose ends
Hung out today with Chad, Ryan and Nick. Ryan and Nick were doing the wrenching and I was opening beers. Chad was offering tech support. Wrenching and beers~
#5
Legacy TMS Member
I dig it! Did he blow the engine or is he just upgrading 'cause he's got the cash? I don't mean to sound sarcastic or anything, just an honest question. It should be a great setup for sure, either way!
#7
Legacy TMS Member
I should have my car in my possession by 10a tomorrow morning, assuming I get outta Dallas sometime today.
#10
Mach 1 Member
They should have had it running by now, it was close to go when I left at 3pm today. Pretty much just needed the throttle body, alternator, air intake and fluids to be ready to start the engine at that point.
#12
Hey guys, We finished 99% this weekend. I had a slight mishap and broke a sensor on the passenger side head so I will have to get one from Ford. Also, my JDM tunes won't be arriving until Tuesday.
I am shooting for 15psi and around 550-575 rwhp on pump gas.
I really enjoyed all the company, we had a great time! Not to mention having 4 sweet mustangs in my backyard! I think that I caused Rich and Chad to further deplete their wallets and buy new stuff after they left.
I'll post up some updated pics later. Maybe I can talk Chad into bringing his video camera over for the startup later this week.
I am shooting for 15psi and around 550-575 rwhp on pump gas.
I really enjoyed all the company, we had a great time! Not to mention having 4 sweet mustangs in my backyard! I think that I caused Rich and Chad to further deplete their wallets and buy new stuff after they left.
I'll post up some updated pics later. Maybe I can talk Chad into bringing his video camera over for the startup later this week.
Thread
Thread Starter
Forum
Replies
Last Post
lysingerjj
2010-2014 Mustang
11
9/9/15 07:56 PM