Pony bars are on
#1
Bullitt Member
Thread Starter
Join Date: October 3, 2006
Location: Pembroke Pines, FL
Posts: 245
Likes: 0
Received 0 Likes
on
0 Posts
Pony bars are on
Just finished installing the pony bar fender emblems
Attachment 20329
see my next post I fixed it.. I guess this will fill up this thread, can't wait to here all the comments *L*
Attachment 20329
see my next post I fixed it.. I guess this will fill up this thread, can't wait to here all the comments *L*
#3
#4
Bullitt Member
Thread Starter
Join Date: October 3, 2006
Location: Pembroke Pines, FL
Posts: 245
Likes: 0
Received 0 Likes
on
0 Posts
ooooops *LOL* all fixed.
Attachment 20337
well that's why I'm here on the forum, you guys can spot my mistakes *L*
Attachment 20337
well that's why I'm here on the forum, you guys can spot my mistakes *L*
#11
#16
ooooops *LOL* all fixed.
Attachment 20337
well that's why I'm here on the forum, you guys can spot my mistakes *L*
Attachment 20337
well that's why I'm here on the forum, you guys can spot my mistakes *L*
Hey Pembroke Pines? I used to live in Hollywood about 10 minutes from that the Hooters at Pines and University
How do you like those MGW fuel rail covers?... Haven't seen them in person yet.......
#17
Legacy TMS Member
Join Date: November 25, 2004
Location: Lehigh Valley, PA
Posts: 989
Likes: 0
Received 0 Likes
on
0 Posts
Looks good. I love mine. I put them on b/c I like the look better than the GT symbol and not for the sleeper effect. Can't tell ya how many times I'm driving through car shows or in a parking lot and I hear people make comments that its a V6. heh heh "FOOLED YOU" - Dark Helmet.
#18
Bullitt Member
Join Date: April 25, 2005
Location: Plant City, FL
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts
Just installed mine today. Went for a little different look. I saw some all chrome ponies that inspired the monochromatic look that I went with. The red and blue bars are covered with silver vinyl and if I don't like it I can peel it right off. I didn't use the 'GT' holes in the fender. I trimmed the tabs off of the backs of the ponies and placed them lower and slightly more forward on the fenders.
#20
Mach 1 Member
Join Date: October 15, 2004
Location: Wisconsin
Posts: 607
Likes: 0
Received 0 Likes
on
0 Posts
Don't toss the GT emblems
The Ponies fit in the original GT emblem holes. Then I cut the pins off the GT emblems and picked up some 3M Trim tape and glued them on the rockers, with red stripes around them.