I tried several times to add a picture as I have done in the past but it doesn't appear to be working.Are picture attachments still working?????

 

Great Mods. I'd like to see more pics of the grille if possible. Inside pics would be great! Thanks!!

 

I can't add picture anymore,tried several times but its not working.Anyone else having problems

 

That light setup is great. Great looking V6

 

Too bad I was looking forward to seeing how you mounted the lights. I am looking for exactly the same lights but they are hard to find. Its hard to tell by your pics, do the lights have pots that they are mounted in? Any info on how you did this would be greatly appreciated.

THANKS

 

Looks great! I would think we would see more Torch Red cars on this site. Makes me pine even more for my ordered GT. How about some more pictures with your daughter's car? Congratulations!

 

Here is a picture of mine with the new lights hooked up and on

 

One more pic with the new lights

 

that looks great Mr. Wick!!!!

 

Those lights look FANTASTIC! What kind are they and where did you get them?

I don't suppose you could provide any instructions on how you mounted them into the grill and such?

Thanks and very nice looking Mustang!

 

Please to the instructions!!! Also, where did you find the lights. I can't seem to find them anywhere!!

 

The lights I used for my grill were called utility lights and here in Florida almost all auto parts store and retail stores(WalMart,Kmart and etc)have them.They are 5 inches in diameter.I cut a 5 inch hole in the outside part of the grill,I could only find a 4 1/2 or a 5 inch hole cutter so I went with the 5 inch one.I would have cut a 4 3/4 inch hole but didn't find a hole cutter that size.You end up setting the light in the hole,aim the light and when you get it the best you can tack the light in place.Remove the grill and then come up with a plan to attach the light to the grill,I melted the plastic removed from the holes with a soldering iron the hold the light in place.You might even try using a hot glue gun to see if that will hold them in place.My wife has several hot glue guns but I didn't think about that at the time.The only draw back to these lights is if the bulb burns out the grill wouold have to be removed due to the fact the screws holding the light together come in from the rear.I don't know if I will have the lights on all that much,just liked the looks.

 

sorry I didn't get back to this thread sooner.... the show is every fourth sat of the month at the donatos on lake underhill and alafaya....

had a great turnout... Mr. Wick I haven't heard from you yet... Drop me an email

Roger

 

Thank you for the info!! How was the wiring? I was reading somewhere that the harness in the V6 is the same as the GT. If so there should be some place to plug/splice these into. Also what did you use for a switch? Thanks again for all your info!!!

 

I do not see any of the pics on page one. Those last two above are the only ones visible. Are others looking now able to see them????

 

I was going to use thr GT light switch.I ordered one through a local Ford dealer and I went to the service deparment to find out if the wiring from the switch to the relay/fuse box under the hood was already there.Also wanted to know if the wiring from the relay/fuse box to the lights was present in the harness.To make a long story short the dealer would not give me that info so I cancelled the order for my switch.I don't know if all this wiring is present or not.I ordered a remote switch so I did not have to run any wiring from inside the car to under the hood.I have a little transmitting fob in the car and a receiver /relay under the hood wired to 12 volts and hooked to the lights.I can turn my new lights on/off with any combination of other lights unlike the way the lights would normally be wired on a GT.I can turn the fog lights on by themselves or with parking lights or high/low beams.The remote switch cost $34.00 where the GT switch was $82.00.The dealer wanted $300.00 to hook the lights up thats when I cancelled my order.I have a total of $70.00 wrapped up in the lights,switch and wiring compared to about $700.00 if I would have bought all Ford GT parts to do it.

 

Thanks for the info Bill. I really appreciate it. Once I find a set of lights I'll give it a go. I like the smaller lights, I think they look way better than the GT ones. Great job on yours it looks very nice!!

 

Had to delete all the pictures in the first part of this topic so I could add the ones at the end.Error message said I had to many attachments so when I deleted the earliest ones I could then add the pics with the lights,thats why you can no longer see the pictures on page 1.

 

Nice looking car!!! Ah AH! I wondered how long it would take for 6 owners to figure out how to add fog lights to lessen the visual differentiation between them and the 8.

Nice job.