Hi. I know this has been discussed before...just can't find the thread. Getting ready to pull the trigger on a Midwest AG Custom Plenum cover. Two questions:

1. MAG picture appears to show rqmt for four bolt points (2 each side). I thought I read somewhere that plenums also require two TB stud replacements.. was that an older design or another plenum?

http://www.midwestautogear.com/index...d=16&Itemid=40

2. Any rub issues (with hood liner) with the MAG plenum covers with a 2006GT? Again, I thought I read the hood liners were redesigned in 07... so looking for input from any 05 or 06 GTs that installed the MAG plenum covers.

Thx.

 

The MAG cover installs with the four bolts as indicated. It's the Ford Factory plenum cover that requires the TB studs.....

I have had my MAG on for about a year and a half, and have had no rubbing issues. I have had my hood liner off and back on a couple of times...

Hope this helps,
Mike