Just installed a new zoom high performance clutch. Now I have a shutter on take off and in reverse. I had the flywheel machined and all bearings replaced with install. Is this normal? Or is the something I can do to smooth it out?

 

Needs time to break in did u replace or resurface the flywheel

 

I had it resurfaced

 

Never mind u did resurface the flywheel just needs to break in

 

I just put it in today. It just shakes quite a bit. I didn't know if that was normal

 

Was the flywheel and disc clean when u in stalled it

 

Yes right out of the box. I made sure not to touch the surfaces

 

Ian running a spec stage 2 shutter at first went away after about 600 miles

 

I'll see how it does after some miles

 

Could it be that the cable needs adjusted? It also doesn't engage until the pedal is half way up.

 

Do still have the stock cable and quadrant

 

Half way up is how it should be. It needs to break in, so give it up to 1000 miles.

 

The stock clutch was lower to the floor

 

Then it wasn't how it should be.

 

It was that way from the factory

 

It should start biting half way from the ground, that's what I've always heard, and that's what a couple members here have said aswell. Mine bites half way, with a stock clutch.

 

Well maybe my description of halfway is different , idk. But it is now further up than my stock one. Is there a way to adjust it?

 

Well maybe my description of halfway is different , idk. But it is now further up than my stock one. Is there a way to adjust it?

 

Yes there is, although I have never done it so I can't really explain it, maybe someone can chime in?