87 foxbody
#5
If that's your limit for now I would go with 3.73 or 4.10 gears in the rear end to give you better acceleration and like 91notch said maf conversion is a must before any big mods are made.
#6
Thanks guys. Yeah I'm just kind of new to this mustang thing. I was going to buy one but my brother just gave me his instead. Its a 1987 mustang GT with the 5.0 and has complete 93 cobra body. It's completely stock I did get a BBK cold air intake for it though. Just want ideas on what can be done to these kind of cars.
#9
Yes sir! For a budget build: a gt40 setup is excellent. The build I'm in the middle of now consists is a gt40 build. Heads ported and polished and 5 angle valve job. Intake ported polished and gasket matched. And a B303 cam.
#10
Nice, right now I'm building a 302 with ported an polished gt40 heads an intake with trickflow stage 1 cam. So far I'm only 500 in the hole an should be able to do it all under 1200.
#11
Cool man! There are several "junkyard secrets" for the fox builder with not so deep pockets! :good
Thread
Thread Starter
Forum
Replies
Last Post