ok i started on pulling apart the 68 and found some p/o b4 me did a hacked up job of bady work, p/o laid new panels on top of old panels and then welded on, pic(s) and measurements i need r of the reardeck area, the peice from where the seam of the trunk lid is to where the quarter panel rolls over,(how that describes it enough) found also they welded new floor pan on top of old floor pan. didnt think left side floor pan was that bad till i started to investagate, thats when i found the torque box is trashed also.....

 

sorry to hear that...I dont know if I can be much help on this one...I 've never gone into floorpans or torque boxes...

 

not so much worried about torque boxes or floor pans as i am more worried about the width of the rear from the edge of the trunk lid to the edge of the quarter panel where it starts to roll down the sides, know what i mean?