Ultra guage? OBDII gauge
#22
I ran MSR, Cresson on Sat with Ultra gauge
It was great able to see ACTUAL engine temp with just a glance
highest I saw was 226 near end of each session
......in the cool down laps I hit the HEATER button...which reduced temps about 20 degrees in only a couple of minutes...
I have the stock Boss grill with the flaux covers still in (not cut out yet)
the air temps in the afternoon was about 91....which I saw in the car.
I was heard Boss goes into limp at 260 engine temps
.....anyone confirm that?
It was great able to see ACTUAL engine temp with just a glance
highest I saw was 226 near end of each session
......in the cool down laps I hit the HEATER button...which reduced temps about 20 degrees in only a couple of minutes...
I have the stock Boss grill with the flaux covers still in (not cut out yet)
the air temps in the afternoon was about 91....which I saw in the car.
I was heard Boss goes into limp at 260 engine temps
.....anyone confirm that?
There is a intake temp and it is in one the main menu's and you can set it to your custom page.
#23
I finally found the A/F setting. But it displays Stoichiometric data vs. Lambda. So you would have to multiply that number by 14.64 to get actual A/F. I think if I set the Wideband O2 guage as well it'll display actual or Lambda. I'll experiment more over the next few days.
I also set ambient and intake temps on the same page, it's surprising how close they are with the stock air box. I'll be testing with the Airaid on next.
I also set ambient and intake temps on the same page, it's surprising how close they are with the stock air box. I'll be testing with the Airaid on next.
Last edited by Hytek; 4/30/12 at 09:15 PM.
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
2015 - 2023 MUSTANG
21
2/10/17 07:12 PM