What to do about rear parking sensors after stripe installation
Thread Starter
Banned
Joined: July 4, 2012
Posts: 2,982
Likes: 0
From: Washington, DC
What to do about rear parking sensors after stripe installation
I'm curious what others have done in this case? I have stripes on my car now, but there is a cutout around my parking sensors. Is it hard to paint them? Is this something I might be able to DIY?
Mach 1 Member
Joined: June 10, 2012
Posts: 748
Likes: 5
From: Southern Oregon
I was worried about that too, so I went with a strip setup that worked out between the sensors... I think yours look fine like that 
if I had gone with wider stripes mine would look like that too...
if I had gone with wider stripes mine would look like that too...
Cobra R Member
Joined: February 9, 2006
Posts: 1,776
Likes: 1
From: NY
like 2k7gtcs said, repainting the old ones, paint may be too thick
Thread Starter
Banned
Joined: July 4, 2012
Posts: 2,982
Likes: 0
From: Washington, DC
Yeah? No impact on sensor ability? I figure the corners are most important anyway.
I just noticed my stripes are a bit wider than yours. Do you measure the exact width of yours?
I just noticed my stripes are a bit wider than yours. Do you measure the exact width of yours?
Last edited by TheDivaDanielle; Nov 9, 2012 at 10:23 PM.
Thread Starter
Banned
Joined: July 4, 2012
Posts: 2,982
Likes: 0
From: Washington, DC
Nope. Major temporarily life and income changing event happened a week ago. Just trying to distract myself, plus i have been without wheels for the last week and didn't feel like taking the metro.
