Post your pics of 2010+ Front and Rear Ends
#261
Shelby GT500 Member
Join Date: March 3, 2004
Location: Richmond VA
Posts: 2,633
Likes: 0
Received 0 Likes
on
0 Posts
If you take your time and cut slowly and then sand the opening smooth its not very noticeable. You can only tell its been cut if you get close underneath. The tail pipes fill the opening well. I'll try to get a closer picture one day if its light when I get off
#262
Shelby GT500 Member
Join Date: January 9, 2012
Location: Oklahoma
Posts: 2,687
Likes: 0
Received 0 Likes
on
0 Posts
Ok that's what I was thinking. If I ever get a 10+ I think it'll be low enough no one will want to get on the ground to look haha. Thanks. Look forward to a picture if you can get one
#263
Shelby GT500 Member
Join Date: March 3, 2004
Location: Richmond VA
Posts: 2,633
Likes: 0
Received 0 Likes
on
0 Posts
Here's a pic of the two side by side. And a close up of the rear during installation. This is as bad as it looked bc I hadn't cleaned up the cuts yet and was test fitting the pipes
Last edited by conv_stang; 2/6/13 at 04:01 PM.
#264
Shelby GT500 Member
Join Date: January 9, 2012
Location: Oklahoma
Posts: 2,687
Likes: 0
Received 0 Likes
on
0 Posts
Not a problem man. You can also go to AM's website. They have a video up of the install on a V6. Nothing different than I saw on mine
Here's a pic of the two side by side. And a close up of the rear during installation. This is as bad as it looked bc I hadn't cleaned up the cuts yet and was test fitting the pipes
#268
I am Shauny Clause
MOTM July 2010 Winner
MOTM July 2010 Winner
Join Date: November 25, 2009
Location: Metro Detroit
Posts: 1,519
Likes: 0
Received 0 Likes
on
0 Posts
A new picture from the 2012 NASA National Championships surfaced this week that I hadn't seen before.
P.S. I know the brake duct hoses are all screwed up.
Wwe trimmed the brake ducts back after this session.
It was kind of a hack job to make my hoses (which I had to keep because of A/C lines) fit in the borrowed carbon fiber 4+" facisa ducts (because I wouldn't drill in his ducts) so we kinda laid them in there (because I was borrowing all this stuff for one week) and they had no support, we rigged up something after this session
Last edited by Stinger1982; 2/19/13 at 06:31 PM.
#270
Shelby GT500 Member
Join Date: January 9, 2012
Location: Oklahoma
Posts: 2,687
Likes: 0
Received 0 Likes
on
0 Posts
#272
Bullitt Member
Join Date: February 1, 2011
Location: Los Angeles, CA
Posts: 304
Likes: 0
Received 0 Likes
on
0 Posts
#274
Shelby GT500 Member
Join Date: January 9, 2012
Location: Oklahoma
Posts: 2,687
Likes: 0
Received 0 Likes
on
0 Posts