Cobra head job
9/3/10 | 07:51 PM
#1
Thread Starter
Mach 1 Member
Joined: April 23, 2008
Posts: 851
Likes: 0
From: Huntsville
Cobra head job
Soooooo the thermostat got stuck shut on the cobra the other week... My father did not realize that the car was overheating and managed to blow the head gasket... The motor was almost hydro-locked. So woodies diagnosed it for us. Its now sitting at Andys Mustangs in Hazel Green. Hopefully it should be back on the road soon....
9/3/10 | 11:32 PM
#2
Mach 1 Member
Joined: December 14, 2007
Posts: 755
Likes: 0
Soooooo the thermostat got stuck shut on the cobra the other week... My father did not realize that the car was overheating and managed to blow the head gasket... The motor was almost hydro-locked. So woodies diagnosed it for us. Its now sitting at Andys Mustangs in Hazel Green. Hopefully it should be back on the road soon....
9/4/10 | 12:04 PM
#3
Thread Starter
Mach 1 Member
Joined: April 23, 2008
Posts: 851
Likes: 0
From: Huntsville
Tell me about it... But I finally met Andy of Andys Mustangs and he was a great guy. I expect to see an excellent job!! Plus while hes got it torn apart the new 2.81" Supercharger pulley is goin on. Can anyone say horsepower?
9/4/10 | 09:19 PM
#4
Mach 1 Member
Joined: December 14, 2007
Posts: 755
Likes: 0
9/6/10 | 07:39 PM
#6
Thread Starter
Mach 1 Member
Joined: April 23, 2008
Posts: 851
Likes: 0
From: Huntsville
so were pretty much redoing all the gaskets. head gaskets intake and plenum gaskets, timing cover and oil pan gaskets and even the rear main seal. All the parts will be in Friday.
9/20/10 | 01:13 PM
#7
Thread Starter
Mach 1 Member
Joined: April 23, 2008
Posts: 851
Likes: 0
From: Huntsville
This actually wound up being the O-rings on the intercooler. Same issue caused it however. But thats all fixed and its driving. Bringing it in tomorrow to have the supercharger pulley put on. So maybe Ill finally be one up on Chads Cobra finally!!!!
Thread
Thread Starter
Forum
Replies
Last Post