5oh5tang

When my 5.0 arrives, my 1st mod will be a catback. I dont like the single tip look that everyone will have. Any chance I can fit dual exhaust tips without replacing the rear valance? I want a set of hooker's on my ***!

WildPony619

I don't know if that will fit without getting a different rear valance. The dual pipe might be too wide for the size of the slot. I actually put those tips on my 91 GT because I had cut outs in my rear bumper. They looked awesome and I even had quite a few compliments. I ended up buying a flowmaster catback system and new rear bumper so they had to go.

Adam

Please don't. My 5.0 can pull it off, yours cannot

dmhines

Not mine ... but here is a picture ...

fritzOSU03

Is it me or does that just look awkward?

dmhines

I think a single rectangular tip would look better than the duals if you really want something different.

Ltngdrvr

Anything other than a 3-1/2" or 4" round tip will require cutting the valance and it will be hard to make it look good.

N8dawg

That looks absolutely terrible.

PTRocks

Just say no. There are plenty of other ways to customize the car.

Ltngdrvr

You could get a Saleen rear bumper cover and have the tips come out in the center, then if you used the twin tips it would look like a vette...

Overboost

Please, save yourself the money and use it on a proper exhaust and don't think twice. That looks awful. Very "I went to Pepboys and had a giftcard and bought these" kind of look to them.

hawkeye18

You might as well get Bowtie exhaust tips. They look that weird.

The Beast

I agree, I had the 4 exhaust tips on a 91 Cutlass Supreme International and always wondered WHY my exhaust was designed to look fake. The idea of them coming out the middle makes it look like it's trying to be some foriegn car or a Corvette, in my opinion.

Stangpilot007

Exactly my thoughts.

SteelTownStang

stangfoeva

Just say no to quad exhaust tips when they aren't meant to be there

laserred38

If the OP is set on them, I think these would look better if the tips were staggered to follow the contours of the rear fascia opening. The inner tip should be flush with the center of the fascia, then the outer tip should be tucked in more, as the outer fascia cuts in away from the car. IMO, if you're going to do it, that's the only way to make it look decent. I'll chop something in a bit so you can see what I'm saying...

DBGB

Please don't do it!!!!

5oh5tang

Thanks for the pic. That doesnt look as good as I hoped. Mine will be painted black & flush with the valance. The saleen rear would probably work!

AusTXMCA

Looks like something that would be on a 'maro