adding subs to a 2012 shaker 500 system
#1
adding subs to a 2012 shaker 500 system
I was wondering how I would go about adding the remote wire to the amp. I have read online and looked at wiring diagrams but nothing is adding up. I was going to attach the remote wire to the amp that powers the door subs. But everything I am reading shows two amps for the door subs.... I only see one right above the drivers kick panel.
Does anyone have the wire colors for the Amp remote wire... is it 12v and if not where should I run the remote wire to turn on the amp?
Does anyone have the wire colors for the Amp remote wire... is it 12v and if not where should I run the remote wire to turn on the amp?
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
2015 - 2023 MUSTANG
0
9/10/15 12:44 PM