Ok, I found this seatbelt for my car. http://www.cjponyparts.com/corbeau-s...-in/p/SBH3PTS/

I have a 2 pt roll bar in my car now, any suggestions on how to install this on it without welding or massive cutting?

Has anyone done this before?

Help.

I did find this attachement bar, do you think it will work with my current roll bar or do you suggest a different course of action.

Left pic is my roll bar installed

The right one is for the attachement bar.

 

Why the harness? Is it for better retention during an autocross or road course event? If you think you are getting better safety than the stock 3-pt. with this, you may want to reconsider.

Before I put the 6-pt in my car, I found the stock setup to be more than adequate for road course and autocross events. Put the seat all the way back, snap the seatbelt shoulder belt to lock it, then bring your seat forward while keeping the belt locked. This locks you in place *almost* as well as a 5/6 pt. harness.

 

More for the shelby looks, i modled mine after a cross of the 66 and 67.

 

I like the roll bar....does it mount to your seatbelt bolt?

Brand and link??

Can you use your existing belts or is the bar in the way?

 

I like the bar too, but where or how did you get the rear seat delete?