05-09 Interior and Audio Mods Enhancing Your Mustang's Interior and Sound System

base stereo's speakers

Thread Tools
 
Search this Thread
 
Old 11/4/06 | 12:09 PM
  #21  
nbk13nw's Avatar
Bullitt Member
 
Joined: April 19, 2005
Posts: 368
Likes: 0
I did the entire car... trunk, floor, quarter panels on front and rear, inside the front doors (Outer skin) and inside door panels that the speaker mounts to. Firewall, tranny tunnel... everything I could get at. The only thing I did not mat was the roof. One thing with FatMat... I also used a spray adhesive on the vertical panels and the ones that are upside down. Just in case things wanted to drop.

I used FatMat since I found it on eBay for under $100.00 for 150 SQ FT.

As for the doors, If not doing the entire panels outside and inside skins, then at least a 10"x10" or larger directly behind the door speakers on the outside door panel.
Old 11/4/06 | 12:17 PM
  #22  
mc_mstng's Avatar
Member
 
Joined: April 17, 2005
Posts: 30
Likes: 0
Is 150 sq. ft. pretty close to what you needed?
Old 11/4/06 | 12:26 PM
  #23  
nbk13nw's Avatar
Bullitt Member
 
Joined: April 19, 2005
Posts: 368
Likes: 0
Yup, had a little bit left over too. Here is a link for an eBayer.

http://cgi.ebay.com/100-fatmat-autom...QQcmdZViewItem
Old 11/4/06 | 12:27 PM
  #24  
nbk13nw's Avatar
Bullitt Member
 
Joined: April 19, 2005
Posts: 368
Likes: 0
Most likely 100 sqft would be enough.. I may have over done some areas, especially in the trunk. I even applied it under the rear deck. And two layers across the entire trunk. Got rid of most of the drone noise inside the car.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
duppycat
General Mustang Chat
2
2/16/19 08:36 AM
CNFLCTD
GT350
4
8/4/17 07:08 AM
Fedupdave42169
2015 - 2023 MUSTANG
1
10/23/15 09:58 AM
tj@steeda
Auto Shows and Events
0
9/30/15 07:02 PM
exgto
2012-2013 BOSS 302
5
9/28/15 07:39 PM



Quick Reply: base stereo's speakers



All times are GMT -6. The time now is 05:50 PM.