After looking through many topics I have yet to find what the diminsions are of the rocker panel stripes. I know there are different sizes, but could some of you post what yours are, including the sizes of each stripe. Just like you did with the rally stripes. Thanks in advance.

 

<div class='quotetop'>QUOTE(ETNOATS @ April 19, 2006, 11:21 AM) Quoted post</div><div class='quotemain'>
After looking through many topics I have yet to find what the diminsions are of the rocker panel stripes. I know there are different sizes, but could some of you post what yours are, including the sizes of each stripe. Just like you did with the rally stripes. Thanks in advance.
[/b][/quote]
I will have to measure the individual stripes later, but the BSM GT300 Rocker Panel Stripes are 3" Wide.
GT300 Rocker Panel Stripes (BSM)

Ok I got home and measured the stripes.
A= Top & Bottom Pinstripes = 1/4"
B= Top & Bottom Gaps = 1/4"
C= Middle Wide Stripe = 2"
Total Width = 3"
[attachmentid=47379]

 

Here's the original measurements from '65.
These are the ones used on the '07 GT500 with the exception of the space between the letters and and the door edge AND the letters and the fender well. The width of that space now becomes a matter of personal preference since that area is so much smaller on the new Mustang compared to the original.

 

I finally decided on just rocker stripes for now (vinyl) and I'm gettting them put on Friday morning. I went with 3" main stripe, 1/2" gap, and 3/4" top/bottom stripe. Main 3" stripe is centered on the bend/curve, which puts the whole "stripe" about 1" from the straight line/door line. I did not want it to be lined up with the "hockey stick"

I will post pix Friday!!!!!!!!!!!!!

 

Thats a great help. I too am going with only rocker stripes for now. Can't agree or afford full stripes right now, other parts to spend money on. Thanks for the info.

 

<div class='quotetop'>QUOTE(nole_trainer @ April 20, 2006, 6:51 AM) Quoted post</div><div class='quotemain'>
I finally decided on just rocker stripes for now (vinyl) and I'm gettting them put on Friday morning. I went with 3" main stripe, 1/2" gap, and 3/4" top/bottom stripe. Main 3" stripe is centered on the bend/curve, which puts the whole "stripe" about 1" from the straight line/door line. I did not want it to be lined up with the "hockey stick"

I will post pix Friday!!!!!!!!!!!!!
[/b][/quote]
I am interested to see how that looks, since the bottom portion of your stripes will be "bending" under so to speak.
I'll keep an eye on this thread. [img]style_emoticons/<#EMO_DIR#>/tongue.gif[/img]

 

check out my new thread with pixs............

http://forums.bradbarnett.net/index.php?showtopic=47481