Midwest Auto Gear Shock Tower Cover install
#1
Midwest Auto Gear Shock (strut) Tower Cover install
*2nd generation covers installed 2/17/07, riding condition has been eliminated* See this thread, post #72 and sub for 1st gen issue.
New pics at bottom of this post.
Midwest Auto Gear Shock Tower Cover Install
This install is so simple, I give it a '1' out of '10' for technical difficulty. Basically, anyone can install it.
Out of the box
Picture of stock strut studs
I applied a liberal amount of grease on the center strut stud (threaded end) because it's prone to corrosion and once covered, I doubt I'll ever take it off.
Cover set into position
Using firm pressure on the center of the cap, press down until it 'snaps' into place.
Shock (strut) Tower Covers installed.
*************************************************
New 2nd generation covers
New pics at bottom of this post.
Midwest Auto Gear Shock Tower Cover Install
This install is so simple, I give it a '1' out of '10' for technical difficulty. Basically, anyone can install it.
Out of the box
Picture of stock strut studs
I applied a liberal amount of grease on the center strut stud (threaded end) because it's prone to corrosion and once covered, I doubt I'll ever take it off.
Cover set into position
Using firm pressure on the center of the cap, press down until it 'snaps' into place.
Shock (strut) Tower Covers installed.
*************************************************
New 2nd generation covers
Last edited by TacoBill; 3/14/08 at 12:47 PM. Reason: sp
#7
#8
It's at 599 MILES.
I'll break 600 tonight when I go to my club's drive-in show. It's history in the making!
#15
Nice, great pics! Looks sweet!
Same here. Maybe I can email them to offer to send in my bar to test with and send me back with the bar some free covers
Same here. Maybe I can email them to offer to send in my bar to test with and send me back with the bar some free covers
#18
#19