LMR CV2 chin spoiler
#4
GT Member
Thread Starter
Join Date: October 25, 2011
Location: Missouri
Posts: 144
Likes: 0
Received 0 Likes
on
0 Posts
I scuffed it and used black bumper paint. Then I used the rattle can touch up paint for the ends and cleared the whole thing. I debated keeping it black but I love the CS look.
Last edited by dirtfan71; 3/29/12 at 12:01 PM.
#8
GT Member
Thread Starter
Join Date: October 25, 2011
Location: Missouri
Posts: 144
Likes: 0
Received 0 Likes
on
0 Posts
These things are tough!!! Tuesday night I was passing an 18 wheeler and it had a blowout. The left front took the blow from the whole tread. The damage included paint gone from chin spoiler, bumper spider webed, left rocker scratched and almost all of the push pins on the inner fender were gone. Did a rattle can touch-up on the chin and it looks good till I get it into the shop. Got a neighbor who is doing front bumper, chin, both rockers and rear bumper for $500.
#13
I know this is an old thread but I just got one of these and as you know it doesn't come with instruction. Could someone tell me how to install it? The spoiler has no pre drilled holes. I'm assuming you use the screws in the wheel well but where do the 2 screws that come with the spoiler go and where exactly does the tape go? Just along the top?
Thanks
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
2015 - 2023 MUSTANG
0
9/16/15 06:44 PM