GT fender emblem
12/9/05, 11:27 AM
#1
Cobra Member
Thread Starter
Join Date: March 30, 2005
Posts: 1,122
Likes: 0
Received 0 Likes
on
0 Posts
Does anyone happen to have a picture of the back of a GT emblem, or have a picture of your fender with the emblem removed? I know that there are locating pins on the emblem. What I don't know is what is the spacing on them, and the pattern they are in. Have new emblems I want to put on, but don't want to start something I am going to wish I would have waited to do.
12/9/05, 05:30 PM
#3
Cobra Member
Thread Starter
Join Date: March 30, 2005
Posts: 1,122
Likes: 0
Received 0 Likes
on
0 Posts
Thanks man. That pretty much answered any questions I had about hole size and location. Of cours now I am bummin because I have fender emblems from a 68 with four pins that are not only too small, but won't line up. Oh well, back to internet shopping 
12/9/05, 05:36 PM
#4
Bullitt Member
If you end-up with extra GT Emblems, I do need a set for the hindquarters of my Bloodhound to complement the forward badges already in-place:
I'm going for a quad look here.
I'm going for a quad look here.
12/9/05, 10:42 PM
#5
Team Mustang Source Legacy Member
Originally posted by hawgman@December 9, 2005, 6:33 PM
Thanks man. That pretty much answered any questions I had about hole size and location. Of cours now I am bummin because I have fender emblems from a 68 with four pins that are not only too small, but won't line up. Oh well, back to internet shopping
Thanks man. That pretty much answered any questions I had about hole size and location. Of cours now I am bummin because I have fender emblems from a 68 with four pins that are not only too small, but won't line up. Oh well, back to internet shopping
Cut the '68 pins off and use the thick 3M emblem tape to put the emblems on your new one.
Thread
Thread Starter
Forum
Replies
Last Post