Cervini concept hood and strut braces
Thread Starter
GT Member
Joined: October 13, 2004
Posts: 171
Likes: 3
From: Greenville, SC
Cervini concept hood and strut braces
I'm just about ready to pull the trigger on ordering this hood for my 06 GT. I have a Strange STB and I'm wondering if this hood will accommodate this or other braces.
In my conversation with the folks at Cervini, they were not definitive in answering this question, so I'm wondering if those of you in the know can give me (and my bodyshop) a better sense of what to expect. I know that the rise is a 1/4 inch taller than stock, so I'm assuming that there shouldn't be a problem. Of course, if there is a fitment issue, I can always remove the STB, but my preference is to keep it on!
In my conversation with the folks at Cervini, they were not definitive in answering this question, so I'm wondering if those of you in the know can give me (and my bodyshop) a better sense of what to expect. I know that the rise is a 1/4 inch taller than stock, so I'm assuming that there shouldn't be a problem. Of course, if there is a fitment issue, I can always remove the STB, but my preference is to keep it on!
Shelby GT350 Member
Joined: February 24, 2005
Posts: 2,227
Likes: 22
From: Delray Beach , FL
I have the RK Sport ram air hood which has air ducting on the bottom and this makes the bottom of the hood closer to the engine than a stock hood. I have the BMR brace and it fits , in fact the brace is raised by a couple of washers to clear my supercharger. So my guess is that you'll probably be OK ...
Thread
Thread Starter
Forum
Replies
Last Post