Aftermarket Spinner's for Bullit Wheels
Thread Starter
legacy Tms Member
Joined: July 30, 2004
Posts: 1,524
Likes: 3
Has anyone tried to fit the 66 mustang wheel spinners on the 05 mustang Bullit wheels?
I found these at Scott drake Products ,there cast and bolt on from the backside .THe 66 center looks good and the 65 might fit as well.Anyone in the know if this will work ,are the center holes the same for fit up?
I would like to use this as I feel this is better than the factory ones now offered.
Here's the spinner.
I found these at Scott drake Products ,there cast and bolt on from the backside .THe 66 center looks good and the 65 might fit as well.Anyone in the know if this will work ,are the center holes the same for fit up?
I would like to use this as I feel this is better than the factory ones now offered.
Here's the spinner.
Thread
Thread Starter
Forum
Replies
Last Post
JonathonK
General Mustang Chat
1
Sep 24, 2015 06:31 PM
Steve@CJPP
Vendor Showcase
1
Sep 15, 2015 06:20 AM